Experimental Investigation of a Solid Oxide Fuel Cell Stack using Direct Reforming Natural Gas

Document Type : Research Paper

Authors

Renewable Energy Department, Niroo Research Institute (NRI), Tehran, Iran

Abstract

In this study, a solid oxide fuel cell (SOFC) stack has been successfully fabricated and tested by using direct natural gas. The main objective of this research was to achieve optimal long-term performance of the SOFC stack without carbon deposition by using low-cost natural gas as a fuel. The stack configuration was improved by a new interconnect design and made of cost-effective raw materials. In this respect, the stack showed maximum power of 31 W while 33 A current was applied at a flow rate of 1000 ccm for H2 (as fuel) and oxygen. Then, humidified natural gas was employed as an internal reforming technique, which showed degradation of 1.4% after 24 h. Maximum obtained power was 32 W under 33 A current at a flow rate of 1000 ccm. After 48 h of operation, 34 W of power was achieved at the current of 38 A. Therefore, the power was increased from 32 to 34 W after 48 h of operation in upper current. Finally, a suitable SOFC stack made of cost effective materials and using direct natural gas under appropriate conditions was fabricated and developed in this research.
    

Keywords

Main Subjects


[1] Hecht, E.S., “Methane reforming kinetics within a Ni-YSZ SOFC anode support”; Appl. Catal. A, 2005, 295: 40.
 
[2] Atkinson, A., “Advanced anodes for high-temperature fuel cells”; Nat. Mater.; 2004, 3: 17.
 
[3] Huang, B., Wang, S., Liu, R., Wen, T., “Preparation and performance characterization of the FeNi/ScSZ cermet anode for oxidation of ethanol fuel in SOFCs”; J. Power Sources, 2007, 167: 288.
 
[4] Douvartzides, S., Coutelieris, F., Demin, A., Tsiakaras, P., “Electricity from ethanol fed SOFCs: the expectations for sustainable development and technological benefits”; Int. J. Hydrogen Energy, 2004, 29: 375.
 
[5] Macedo, I., Seabra J., Silva J., “Greenhouse gases emissions in the production and use of ethanol from sugarcane in Brazil: the 2005/2006 averages and a prediction for 2020”; Biomass Bioenergy; 2008, 32: 582.
 
[6] Aslannejad H., Barelli L., Babaie A., Bozorgmehri S., “Effect of air addition to methane on performance stability and coking over NiO–YSZ anodes of SOFC”, Applied Energy, 2016, 177: 179.
 
[7] Aslannejad H., Bozorgmehri S., Babaeia A., Mohebi H., Ghobadzadeh A., Haghparast A., Davaria S., “Effect of Operational Condition on Performance and Durability of Solid Oxide Fuel Cell Fueled by Natural Gas”, ECS Tansactions, 2013, 57: 2939.
 
[8] Cimenti M., Hill, J. , “Direct utilization of ethanol on ceria based anodes for solid oxide fuel cells”, Asia-Pacific J. Chem. Eng., 2009, 4: 45.
 
[9] Resini, C., Delgado, M., Presto, S., “Yttria-stabilized zirconia (YSZ) supported Ni-Co alloys (precursor of SOFC anodes) as catalysts for the steam reforming of ethanol”, Int. J. Hydrogen Energy, 2008, 33: 3728.
 
[10] Ghobadzadeh A., Mohebbi H., Raoufi A.,  Aslannejad H., Davari S., “Fabrication of Solid Oxide Fuel Cell Using the Dual Tape Casting Method”; ECS Transaction, 2011, 35: 551.
 
[11] Mermelstein, J., Millan, M., Brandon, N., “The impact of carbon formation on Ni-YSZ anodes from biomass gasification model tars operating in dry conditions”; Chem. Eng. Sci., 2009, 64: 492.
 
[12] Gavrielatos, I., Drakopoulos, V., Neophytides, S.G. , “Carbon tolerant NieAu SOFC electrodes operating under internal steam reforming conditions”; J. Catal.; 2008, 259: 75.
 
[13] Rosa L., “Mitigation of carbon deposits formation in intermediate temperature solid oxide fuel cells fed with dry methane by anode doping with barium”,  J. Power Sources, 2009, 193: 160.
 
[14] Baker, R., “Catalytic growth of carbon filaments”; Carbon, 1989, 27: 315.
 
[15] Farnoush H., Abdoli H., Bozorgmehri S., “Cu-Doped Nano- La0.8Sr0.2MnO3 Protective Coatings on Metallic Interconnects for Solid Oxide Fuel Cell Application”, Procedia Materials Science, 2015, 11: 628.
 
[16] Janardhanan V.M., Heuveline V.,  Deutschmann O., “Performance analysis of a SOFC under direct internal reforming conditions”, J. Power Sources, 2007, 172:296.
 
[17] Fu Q., Freundt P., Bomhard J., Hauler F., “SOFC Stacks Operating under Direct Internal Steam Reforming of Methane”, Fuel Cells, 2017, 17: 151.
 
[18] Chen T., Li T., Miao H., Wang W. G., and Wu Y., “Operation of Ni-YSZ Anode Supported Solid Oxide Fuel Cell on Different Simulated Syngases”, ECS Transactions, 2009, 25: 1905.